Riverside, Ca –
- Project Objective:
- Designed the transmitter within the search range of the receiving antenna
- Identified the received signal as a sampled version of the transmitted one
- Aligned to the measured max power received
- Achieved the scanning time less than 8 minutes
- Experimental Hardware and Software Setup:
- 2x USRP-2901 SDR
- Arduino Mega 2560
- Adafruit Ultimate GPS Breakout
- HS-5645MG Digital Servo Motor
- Actuonix P16 Linear Actuator
- 2x 27 dBi 5.8 GHz Directional Antenna
- LabVIEW 2016
- Project Outcomes
- Successfully found TX in the search range
- Aligned RX to the direction of the max power received
- Achieved around 5 minutes for the whole process
- Achieved small increments of servo and actuator control